Prime Laser SolutionsMobile laser cleaning, North Queensland

Yes. Prime Laser Solutions is fully mobile. Bigger jobs are done on site, and smaller parts can be collected and returned. We're based in Proserpine and work across the Whitsundays, Mackay, the Bowen Basin and North Queensland.

No. Settings are tuned to each job and surface to avoid heat damage, pitting or warping. The laser removes the rust, paint or grime and leaves the metal underneath intact, so part numbers and cast lettering stay readable.

Rust, corrosion, paint, coatings, grease, oil, carbon, antifoul, marine growth, graffiti, soot and mould. It works on steel, stainless, aluminium, cast iron, brass, chrome, fibreglass, timber, stone, brick, concrete and some plastics.

Cleaning time depends on the component, the type of contamination, and how heavily it is built up. As a guide, a dump truck differential centre took approximately 2.5 hours to clean using our 500 W laser. On comparable heavy-duty jobs, our 3,000 W laser can reduce cleaning time by roughly half, depending on the condition of the component.

No. The equipment can't run in the rain, so outdoor jobs are weather dependent. We'll reschedule if the weather turns.

Power (240V single phase 15A or 415V three phase 32A), access to the item, and room to set up a cordoned work area. If there's no power, a generator can be supplied at extra cost.

Send a photo of the job through our contact page with your location and rough size, or call us on 0436 010 447. We usually reply the next day, and larger jobs can get a free demo.